Re: What does the switch do?

Date: May 12, 2008 at 23:09:28
From: Don Mare
Subject: Re: What does the switch do?

- just two areas need addressed on the pups -
1- is the base plate on the bridge pup - just open it up add some wax - heat it till wax runs - and tighten it down by temporarily using the 3- screws without springs -

2- the cover of the neck pup needs 1/8" layer of wax in the head of it - so it melts between the cover and the head of the pup --

Squeal is caused by air gaps between two surfaces - it allows the signal to bounce and multiply andis sent to the amp as squeal - the amp completes the circle and it becomes feedback..

the mixture is 40%beeswax 60% paraffin the temp is about 140* to 180*

I just use the Blow Dryer - or solder Iron's shaft to apply the heat --

Don Mare Pickups www.donmare.com

View the previous message in this thread

Go to the top of this thread

View entire thread

[Previous Message] [Next Message]

Follow Ups:

[Telecaster] [FAQ]

[pool-71-107-122-76.lsanca.dsl-w.verizon.net]